Corner Pantry Cabinet is important to use as much kitchen space as possible. The tricky part about this type of cabinet is the face frame. For a good fit, it is a good idea to determine the width of the frame after the shell of the cabinet has been installed. This will eliminate gap between the wall and the casing.
Place plywood on a work table. These are the end panels in the corner cabinet. Measure 4 inches up from one end and make a selection. Place the Corner Pantry Cabinet hook on the mark and draw a line over the 23 “width of the gavel. Repeat this for the other end panel. This is for cleat, which will support the bottom shelf. If that helps, write the word “bottom” below the line to mark the bottom of the end panel.
12 Picture Gallery: Installing Corner Pantry Cabinet
Make a mark on the line from the previous step 4 inches from the edge. From this brand, drag a perpendicular line down to the bottom edge of the end panel. This will give you a 4-fold-4-inch square. Cut this out with jigsaw. Repeat this for the other end panel. That’s where kicks will be installed.
Arrange the gables on the table so that the toe kicking slots are away from each other. Measure from the bottom and make a mark of 15¾ inches. Place the angle hook on the mark and draw a line parallel to one for button. Put an “X” on the top of the line. Repeat this for the other end panel. That is where the center shelf will be installing Corner Pantry Cabinet.
This post topic: Room House Ideas